Print Page - Expected output file was not found

Title: Expected output file was not found
Post by: Vortichez on October 04, 2016, 07:57:32 AM

I am having problems saving and reloading my files after using Morph Bridge.

I convert my progress into a wav and save in my library.

Reopening Soundshaper and running Morph Bridge again, with this new wav and a second wav as inputs, yields the following error:

Expected output file c:\cdpr\Temp\~A_1_c1.ana was not found

ERROR: INVALID DATA
ERROR: Incompatible original-sample-type in input file ~B_0_c1.ana.
ERROR: INVALID DATA
ERROR: Incompatible original-sample-type in input file ~B_0_c2.ana.

I have tried manually clearing the Temp folder and also converting the file to ana but get the same error.

Title: Re: Expected output file was not found
Post by: loganmcbroom on October 04, 2016, 05:05:08 PM

I don't know this error specifically, but maybe try housekeep respec to a couple different rates? I'll test it out and see what I get.

Edit: Using different sample rates in the inputs I get:
[CDP] ERROR: INVALID DATA
ERROR: Incompatible original-sample-rate in input file C:\Users\Logan\Desktop\Altar\Altar1475597392231\3_altar.ana
So not quite right, but it leads me to think your files have different bit depths. I don't know off hand how to modify bit depth in CDP but if that is the issue I'm sure someone on here knows.

Title: Re: Expected output file was not found
Post by: Vortichez on October 04, 2016, 05:17:30 PM

I will try changing them and get back to you! Thanks! :)

Title: Re: Expected output file was not found
Post by: Vortichez on October 04, 2016, 05:40:25 PM

You were absolutely right!

The second input was a bounce from Logic at 24 bit. I'll remember to bounce at 16 next time :D

Thank you.

Composers Desktop Project Forum

General Category => General Board => Topic started by: Vortichez on October 04, 2016, 07:57:32 AM