General Category > General Board

Problems with multichannel shred

(1/2) > >>

OHT:
hi :)

i keep getting this message when i try to use multichannel shred:

Cannot Read The Header Of The Output File 'cdptest0.wav'
The CDP Process May Not Have Functioned Correctly

followed by:

DoOutputParse failed

anyone experiencing the same? and maybe even knows how to solve this problem?

cheers

otis

simonk:
Hi Otis,
Is that a mono file ?
It should be for Mode 1
If you want Mode 2 you probably should look into setting the appropriate multi-channel  header for you useage.
Have a look here

http://www.ensemble-software.net/CDPDocs/html/cmcrefmn.htm#CHANNELX

SFPROPS will report details on files & then there are several utilities to setup headers etc.

hth
Simon

OHT:
Hi Simon

Yes ive always used mono files.
and now multi channels texture also stopped working  :-[
it creates a file but im unable to play it.
even when i save it there is just no sound i've tried different files and configurations but that doesn't change anything.

any idea why that might be? it is a bit of an urgent matter as im to present my piece in school in two weeks time.

thanks for helping

cheers
otis

simonk:
Hi Otis,
Try running your new output file through SFPROPS & see what it reports.

Does the file play in any other appication?

I'm assuming your soundcard/device can handle & is configured for muti-channel outputs & you've tested all that.

+
Are you sure that you must use the CDP system for this?
You are in a very complicated area that  will suck time hugely just to run through permutations of  a single event.

There are quite a number of other sound diffusion apps around these days that you might use given your tight time schedule.

OHT:
thanks for replying so quickly!

i have de- and then re- installed the program and know its working again. no idea what went wrong.

and your right about other programs i just like soundloom so much :)

cheers
otis

Navigation

[0] Message Index

[#] Next page