1
Mac installation / pvoc analysis error
« on: June 04, 2014, 03:06:54 PM »
Hi all,
I'm making my first steps in CDP, and i'm running into some difficulties..
I've installed cdp using the installer package on mountain lion, 10.8.5.
I intend to use CDP from the command line.
It looks like "simple" processes work nicely, but when i try to make an pvoc analysis file, for instance by running the following line;
pvoc anal 1 bd.wav bd.ana
the program returns:
ERROR: INVALID DATA
ERROR: Cannot open output file bd.ana
I'm sure there must be some beginner's mistake involved, but i can't seem to figure out what it could be.
The sound file i'm using is 44.1khz, 16 bit, mono, as "dirsf" shows;
Bytes Channel Sample Rate Seconds fmt Name
29436 1 short 44100 0.334 W bd.wav
Any suggestions would be very much appreciated!
I'm making my first steps in CDP, and i'm running into some difficulties..
I've installed cdp using the installer package on mountain lion, 10.8.5.
I intend to use CDP from the command line.
It looks like "simple" processes work nicely, but when i try to make an pvoc analysis file, for instance by running the following line;
pvoc anal 1 bd.wav bd.ana
the program returns:
ERROR: INVALID DATA
ERROR: Cannot open output file bd.ana
I'm sure there must be some beginner's mistake involved, but i can't seem to figure out what it could be.
The sound file i'm using is 44.1khz, 16 bit, mono, as "dirsf" shows;
Bytes Channel Sample Rate Seconds fmt Name
29436 1 short 44100 0.334 W bd.wav
Any suggestions would be very much appreciated!